DDGR1 Dual Gear PRO-X Rotary Polisher

DDGR1 PRO-X — Dual Gear Rotary Polisher

The D-TAIL LAB DDGR1 PRO-X is a torque-focused rotary built for fast, consistent correction. Dual-gear drive delivers powerful, stable rotation under load, while a soft-start trigger, large 6-speed dial, and balanced chassis keep the tool smooth and predictable on modern clear coats.

Why You'll Love It

• Dual Gear Technology — increased torque and stall resistance for efficient cutting.
• Soft-start + progressive trigger for clean product spread and control.
• 6-speed electronic dial to fine-tune RPM for compounding, polishing, or finishing.
• Shop-ready details — 3 m detachable heavy-duty cord, locking trigger, side brush access, spare brush set, and screw-on side handle.

Specs

• Power: 1050 W heavy-duty motor
• Voltage: 110–120 V
• No-load speed: 700–2400 RPM
• Spindle thread: 5/8"
• Weight: 2.4 kg
• Cord: 3 m (10 ft) detachable heavy-duty
• Backing plate: 5" (Ø125 mm)

Pairs Well With

• Backing plates: Rotary Backing Plate(s)
• Cutting pads: X-TRA Cutting Red Foam, X-TRA Cutting Grey Microfiber, XXX-TRA Cutting Merino Wool
• Finishing pads: XX-TRA Fine Finishing Black Foam, UNI-X Purple Foam
• Compounds & polish: CORSA — Advanced Correction Compound, Gran FINALE — Jeweling Paste

How To Use

1. Plate & pad: Install a 5" rotary plate; center a clean pad.
2. Prime: Add 3–4 pea-sized drops; dab around the section.
3. Start slow: Feather the soft-start trigger to spread product, then set the dial for the task (lower RPM for finishing, higher for cutting).
4. Work the paint: Keep the pad flat; use controlled arm speed and light, even pressure. Avoid dwelling on edges and body lines.
5. Inspect & refine: Wipe residue, check results, then switch to a finer pad/polish for maximum gloss.

Notes: Rotary polishers correct quickly but require experience. Use paint depth measurement where possible, and always work on cool panels out of direct sun.